Kitchen Backsplashes / September 6, 2018 / Edward Taylor
Tired of the same old tiled backsplashes? Try something different like a herringbone shim backsplash. Cut the shims to size and then create the middle section starting at the center line. Glue down the section and let it sit for several hours. Then, once you apply it onto the wall, you can start adding all the filler pieces. It’s important to measure correctly.
This next backsplash does resemble one we described earlier, but the stones used are a different size and are installed using a very different technique. These little stones cost around $2.50 per square foot so expensive is not part of the equation. If you want to do this or something similar, the effort required for this DIY project is less than you might expect to create the finished wall you see here. Apply the required grout carefully to the wall area, smoothing it over the entire surface. Then take each irregular shaped sheet of small stones and place it on the grouted wall, setting each sheet so the stones eventually cover the entire wall in an interlocking pattern. Voila, the garden stone kitchen backsplash is now ready.
You MightAlso Like
Ours Editor Picks ofThe Week